Fife Csp-01 Manual -

Physically push the steering guide (e.g., Fife GPE or GMA frame) to its mid-stroke position. Measure the stroke length with a tape measure to ensure equal travel in both directions.

A: You have enabled "Economy Mode" or "Reduced Stroke." Check DIP switch SW2-4. Setting this to ON limits stroke to 25% to protect damaged guides. Turn it OFF for full stroke. Fife Csp-01 Manual

Hold the web material in the sensor gap. Press and hold the "Calibrate" button on the sensor amplifier (or the CSP-01 board if equipped) for 5 seconds. The LED will flash twice, indicating the "web present" value is stored. Physically push the steering guide (e

If you see a fast blinking red light, the manual instructs you to check the sensor voltage (should be +15V between pins 1 and 7 on the sensor connector). 4. How to Calibrate the CSP-01 (Step-by-Step) The calibration process is the most intimidating part for new users. According to the official manual, calibration ensures that the "web center" matches the mechanical center of the guide. Here is the simplified procedure: Setting this to ON limits stroke to 25%