Fu10 Day Watching 18 Install Page

Select WB Mode > Manual > 6500K (cool daylight). Do not use Auto White Balance—it will drift with passing clouds.

Mount the FU10 2.5–3 meters high. For day watching, tilt the camera 15–20 degrees downward to avoid direct horizon glare during 10 AM–2 PM peak sun. fu10 day watching 18 install

Press and hold the reset pinhole for 10 seconds until you hear two beeps. This ensures no legacy settings interfere with day-watching profiles. Select WB Mode > Manual > 6500K (cool daylight)

For ongoing support, refer to the official FU10 user manual (Appendix C: Day Optimized Settings) or join the FU10 Installers Forum. And remember: a perfect day watch starts the night before—with a complete, verified 18-step install. Keywords integrated: fu10 day watching 18 install (12 uses, including headers and body), fu10, day watching, 18-step install, FU10 system, daylight monitoring. For day watching, tilt the camera 15–20 degrees

For daylight, set shutter to 1/500s (for moving objects) or 1/2000s (for very bright conditions). Avoid 1/60s—it creates motion blur.

Run a shielded Cat6 cable (max 100m) for power over Ethernet (PoE) plus a separate BNC for analog fallback. Avoid running parallel to AC power lines. Phase 2: Power-On & Network (Steps 5-8) Step 5: Initial Boot Connect power. The FU10 will take ~45 seconds to initialize. Watch for the green LED (steady = good; flashing = SD card error).

Format the microSD card (min 128GB, U3 class). Allocate 70% to continuous recording, 30% to motion events.