Ka 54 Remsl Top -

| Symptom | Likely Cause | Solution | |---------|--------------|----------| | External leakage at rest | Incorrect groove depth or seal compression | Remachine housing; replace seal | | Chunking or tearing | High pressure spikes beyond 500 bar | Install backup ring; reduce system pressure | | Hardening/cracking | Fluid temperature exceeding 125°C | Add cooler; switch to FKM version | | Spiral twisting | Uneven rod extension speed (pulsation) | Optimize pump flow; check rod straightness | | Abrasion marks | Contaminated fluid (ISO 21/18 or worse) | Change filters; flush system |

Introduction In the world of precision engineering and industrial machinery, part numbers are the DNA of maintenance and repair operations. One such designation that has been gaining traction among technical specialists and procurement officers is the KA 54 REMSL TOP . While the alphanumeric string may seem cryptic at first glance, it represents a critical component within specific mechanical assemblies. ka 54 remsl top

| Specification | Value | |---------------|-------| | Component Type | Rod or Piston Seal | | Nominal Diameter (d) | 54 mm (Inner) | | Groove Width (L) | 8.1 mm to 9.5 mm (depending on housing) | | Cross Section | Asymmetric, with scraper lip | | Material | TPU + PTFE bronze-filled (TOP grade) | | Hardness (Shore A) | 92 ± 2 | | Max. Pressure | 450 bar (static), 350 bar (dynamic) | | Max. Speed | 0.5 m/s | | Temperature Range | -35°C to +110°C (intermittent +125°C) | | Fluid Compatibility | Mineral oils (HLP), synthetic esters, water-glycol | | Symptom | Likely Cause | Solution |

A: The TOP grade integrates an anti-extrusion element. However, for continuous pressures above 400 bar, a separate PTFE backup ring is advised. However, for continuous pressures above 400 bar, a

A: Stored in cool, dark, and dry conditions (<35°C, no ozone), it lasts 10 years.

For further technical support, consult the original component manufacturer's catalog or a certified fluid power engineer. Part numbers and specifications mentioned are based on industry standards. Always verify with your OEM documentation before ordering or installing.