Virtual Device Serial0 Will Start Disconnected (Complete × OVERVIEW)

In a real Cisco router, Serial interfaces use . If no cable is plugged in, the interface remains "down/down." However, emulators are not real circuits. If an emulator tried to auto-detect every possible connection at boot, it would slow down the entire lab startup process.

A: The message is printed during boot order, before the emulator has fully initialized the virtual PCI bus and links. It may appear briefly and then be overwritten. If the interface comes up/up after boot, ignore it. If it stays down/down , your link is faulty. virtual device serial0 will start disconnected

config t interface serial0 no shutdown After this, show ip interface brief still shows Serial0 down/down . In a real Cisco router, Serial interfaces use

The no shutdown command fixes administratively down (interface disabled by software). It does fix hardware down (no cable, no carrier signal). The "virtual device will start disconnected" message is a hardware-level notification. You cannot fix it with IOS commands; you must fix it in the emulator GUI. The Clock Rate Caveat (DCE vs DTE) Even after you connect the virtual cable, you might still face a down/down or up/down status. After fixing the "start disconnected" message, ensure you have a clock rate set on the DCE side. A: The message is printed during boot order,

Always read the console boot messages. That "disconnected" line is not a warning; it is a direct status report. Frequently Asked Questions (FAQ) Q: Does this happen on real Cisco hardware? A: No. Real hardware will show "%LINK-3-UPDOWN: Interface Serial0/0, changed state to down" if no cable is plugged in, but it will never announce "virtual device."

The short answer is: